Behind.ĪBEAM – At right angles to the keel of the boat, but not on the boat.ĪBOVE DECK – On the deck (not over it – see ALOFT)ĪDRIFT – Loose, not on moorings or towline.ĪGROUND – Touching or fast to the bottom.ĪIDS TO NAVIGATION – Artificial objects to supplement natural landmarks indicating safe and unsafe waters.ĪLEE – Away from the direction of the wind. 1, 2009.By Darla Kinney Scoles In case readers might suspect that Doris is overstating her disadvantage in not knowing the terminology of the nautical world, here is a certainly-incomplete list of words Charles was tossing her way:ĪBAFT – Toward the rear (stern) of the boat. "Modern scout leaders 'don't need to know how to tie knots.'" Nov. "Tie the Fisherman's Knot." (May 17, 2015) "Boy Scouts movement begins." (May 20, 2015) "Lost knowledge: ropes and knots." Low-Tech Magazine. "How to untie a Figure eight Loop." (May 14, 2015) "First Class Rank Requirements." (May 13, 2015) "Scout Requirements Study Guide." (May 13, 2015) "The Seven Need-To-Know Climbing Knots." Backcountry. "Constrictor Knot (Twisting Method)." Nov. "Andy's Most Useful Knots." (May 11, 2015) If the constrictor doesn't sound ominous enough, there's also a double constrictor - basically the same knot tied twice. Sometimes, the knot can damage or scar the item it's tied around. In that case, the knot's binding force is concentrated over a smaller area, which gives it an extra hard bite. In some cases, it may be impossible, especially if you used a small line. Like the double fisherman's, the constrictor is a really difficult knot to untie. If you intend to tie it over a hard surface, in contrast, a soft, stretchy one is best. If you'd like to tie a constrictor over something soft, the knot will hold better if you use a hard, stiff cord. Also called a gunner's knot, whip knot and timber knot, this particular knot is used to bind a rope very tightly to an object, such as tying a boat to a pole. The double fisherman's is one tough knot, it's true. The other side should show four neat rows of wound cord. If you've properly tied a double fisherman's knot, each knot should have an X on the same side. After you've created and tightened the second knot, pull each rope's main ends (not the short ends by the knots), and the two knots will slide together.So if you started winding the blue rope by moving it over the gold rope, take the blue rope and start winding it by moving it under the blue rope. Take that lengthened gold rope and repeat the earlier steps, only wind the gold rope in the opposite direction than you'd wound the blue rope. Now take the short end of the gold rope, and pull a little to give yourself more rope to work with.Now take the blue rope and pull it back through the inside of the loops or coils that you've just created and pull to tighten.Take one end of the blue rope and wind it loosely twice near the end of the gold rope.For ease of explanation, let's assume one is gold and the other is blue. Set your two pieces of rope side by side.So how did it get the name "double fisherman"? Since it's easy to tie, it works well on small lines, such as fishing line. Kayakers and canoeists, for example, sometimes use it with short pieces of rope to create grab handles for their watercraft. It's common in climbing and other sports. Interestingly, the double fisherman's knot is rarely used in fishing. Over time, the knots sort of seal themselves as one, and often the only way to undo the thing is to cut the knots out. Actually, it's two knots that slide together. The double fisherman is a knot used to tie two ends of a rope or cord together. And it got this name not because it's impossible to tie - it's actually quite easy - but because it's nearly impossible to untie. The impossible knot isn't its technical name it's actually a nickname for the double fisherman's knot. Even when it comes to the impossible knot. Pretty much anyone can master the art of knot-tying.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |